Scalar Research

Pure Wireless Mode of Spooky2 Scalar

Can Spooky2 Scalar be useful in wireless mode? Jeff did a quick test, which based on scalar theory suggested was possible. Please check the details below:

I removed the floating ground link cable and tested to see if I could still get the receiver box to show me that the power was flowing. Some would attribute this to true wireless transmission of power, some will still argue it — to each their own.

In any event, here are two pictures of both the coil tester being energized by the receiver coil without the link cable connected. The picture above shows the coil tester lights up. In the picture below, the LED on the receiver box is turned on, which robs the power to light up — hence the coil tester goes dark. Both of them prove that Spooky2 Scalar can work in wireless mode.

Note: It is still better to run the Scalar system with the link cable attached. It makes it less sensitive to environmental factors and easier to tune.

Authored by Jeff Kaczor

Leave a Reply

Your email address will not be published.